|
THERMOWELD FOR LIGHT OR WHITE COLOR FABRIC.
This new transfer paper for color inkjet
printers can be printed with 1440dpi and is especially suitable for
high-resolution photographs. You can image all colored fabrics made of cotton
or cotton blend, as well as synthetic fabrics (polyester, nylon, etc.).
Create your own t-shirts, caps, mouse pads, bags etc
Note:
This media (the Thermo weld) is offered
for both Dark Colored fabric (T-Shirts) and light colored fabric. This page
features the Light Color Thermo weld intended for LIGHT colored or white
T-Shirts. Please make sure you order the correct type.
Printing
Use single sheet feeding only
Print on the coated, rough side of the transfer
paper in right reading, not in mirror image! -
Do Not Use T-Shirt Transfer Setting
For best results use high-resolution or photo-quality
option
Trim away the unprinted paper around your
image with scissors. Generally it is recommended to increase color brightness
and or saturation when printing.
Transfer with heat press.
Hand iron instructions on back
of this sheet.
Remove
paper backing from transfer film Tip:
Tear paper backing slightly, about 1/8 inch, for easy removal of paper
backing
or use exacto knife in corner between film and backing paper
Position imaged transfer film on garment
with printed side face up Cover imaged transfer film with enclosed silicon
paper then cover it with 5 sheets of normal paper (pre-pressed to take out
the moisture) Onto cotton/cotton blends: Press at 375°F using maximum pressure
for 50 seconds*
Onto synthetic fabrics: Press at 350°F using
maximum pressure for 25 seconds*
Allow silicon to cool completely and peel
off.
*High pressure is very important
for high image quality and good wash ability. Under low pressure the black
toner might bleed.
Washing
Instructions.
Always turn textile inside-out before washing
Machine wash warm water - 40°C
HANG DRY ONLY
Do not use harsh or bleaching materials
After washing we recommend turning shirt
inside out and ironing the image from the back
Read all instructions carefully before
use.
-
Iron on a hard surface, NOT
an ironing board. Place a pillowcase or t-shirt between your hard surface
and your garment to allow the heat to penetrate the transfer.
-
Remove
paper backing from transfer
film
-
Tip: Tear
paper backing slightly,
about 1/8 inch, for easy removal of paper backing or use Exacto knife in
corner between film and backing paper.
-
Position imaged transfer film
on garment with printed side face up ,
-
Cover imaged transfer film
with enclosed silicon paper. (This is to' protect the imaged transfer
film).
-
Adjust iron at highest temperature
setting
Step press, with firm pressure, slowly
along each side of the image. Hold each press for 45 seconds, ensure all
edges and corners are firmly pressed. Continue to step press over the
entire image, again each step press should be held for 45 seconds until
entire image has been pressed and all areas have been pressed for 45 seconds
each. Allow silicon to cool completely and peel off.
Total ironing time should be 5 to 6 minutes
for 8.5 x 11 size image.
home |
help| about us |
e-mail
HPS LLC. Copyright 2003-2007 texascraft.com
|
