White Glossy Inkjet Adhesive Vinyl.

HYAZ TM Inkjet Media

1) Copy/Print on to the coated side of the media using a compatible Inkjet Printer.

2) To prevent a paper jam, make sure the vinyl is not bent, warped, or corners folded BEFORE loading. Loading by hand ONE SHEET at the time (pressing FF/Ready) is a way to make sure it loads correctly.

3) When gluing a vinyl label to any surface, clean the surface and remove residual grease, soot, or dust.

4) It is not recommended (on larger labels like 11" X 17") to remove all the back paper before installing. It’s better to remove the paper from a small area at one end first such as a 1/2" vertical strip at the left hand or right hand edge.

5) Line up your label. When the position looks correct, let the label make contact with the surface on the edge where you removed the back paper.

6) Now bend the label back and carefully remove the rest of the protective back paper, and glue the label down working from the end you glued first. Then work your way towards the other end holding that end away from the surface. You can use your finger or a sponge and only press down (glue) a small area each time to prevent trapping air bubbles. Do not use excessive pressure when working the label to prevent smudging the ink.

7) If the label is used outdoors you must use clear spray and over laminate. The Over laminate must be applied in such way that it prevents water from contacting the label. Clear enamel spray is available here or in most hardware or automotive parts stores.

We have now several new types of texture over laminate. Please use the links on the top of the page.

You can spray the label before you apply it (after printing) to prevent over spray. Fixative spray is available in most craft stores or you can use the clear spray offered here or sold in most automotive parts stores. Use our WOL over laminate together with the spray. Using clear spray as the only protection will offer limited water proofing.

To extend UV resistant of Inkjet media HPS offers over laminate with built in UV barrier.

Printing and Application Instructions

Printer Settings

If your printer is not listed here then select transparency and normal resolution.

For a complete updated list of our media and to order on line go to

www.texascraft.com/hps or call 817-489-5249

General: If you are working with 4.25" x 11" vinyl you can try removing all the backing material and then use the technique described above.

NOTE: If using self adhesive media, note that any adhesive may become difficult to remove over time. If you want to use self adhesive media on automobiles or other items where you don’t want the label to become permanent or difficult to remove after long periods of time we recommend our selection of media with removable adhesives.

Disclaimer: We have tested our media in various personal inkjet printers with good results. The user of this paper/film must determine the suitability of this product before beginning production, using his equipment and method of application. The sellers and manufactures maximum obligation shall be to replace paper/film that has been found to be defective. Neither the manufacturer nor the seller shall be held liable for any injury, direct or consequential, arising out of the use of, or inability to use this paper/film.

home | help| about us | e-mail

HPS LLC. Copyright 2003-2007 texascraft.com